Installation Guide Blind Roller

NOTE: It will be easier to install large shutters with two people.

In the RECESS assembly:

Roller blinds

Your blinds come with brackets and safety devices must be installed child by law.

1. With each awning bracket, you will receive a male and female bracket. The male support is used to control the side chain which, on the female side is used for the end of the spindle (no control side)

2. Drill 2 screws in each bracket. How Please ensure that the male bracket is placed on the same side you ordered as its "control" side.

3. Take a look at your initial order, look for the roll style blinds. If "roll forward" has been ordered, make sure the fabric on the front of the tube. If you ordered "Roll Back".

4. First, enter the control side chain of the (male side) blind. Before inserting the blind, make sure you have both marks in the control chain up. This means that the chain is suspended evenly at the front and back of the chain drive.

5. While holding the control side in the bracket, guide the end of the female receptacle female slot spring pin and push until the spring snaps into place.

6. Your awning is now locked in position and can be easily operated by pulling on a front side of the chain to lift and not to the back of the chain to lift the roller shutter.

7. When the shutter is lowered to the correct position, please add the chain stop where the chain enters the chain. This will prevent the blind from rolling too far and damaging the flap.

8. Finally, hold the child's safety device to ensure that the cables are out of the reach of children.

Roller blinds

External face fitting:

Your blinds come with brackets and safety devices must be installed child by law.

1. With each blind bracket, you will receive a male and female bracket. The male support is used to control the side chain which, on the female side is used for the end of the spindle (no control side)

2. Attach the brackets to the window frame or wall where the needs are and mark through the holes with a pencil. (Note that the measure given us from the outside of the male will rise outside the female support)

3. Drilling a small 2 mm pilot hole will cause the screw on its supports to be much easier. Screw the brackets to the wall or a frame ensuring they are the right window.

4. First, enter the control side chain of the (male side) blind. Before inserting the blind, make sure you have both marks in the control chain up. This means that the chain is suspended evenly at the front and back of the chain drive.

5. While holding the control side in the bracket, guide the end of the female receptacle female slot spring pin and push until the spring snaps into place.

6. Your awning is now locked in position and can be easily operated by pulling on a front side of the chain to lift and not at the back of the chain to lift your shadow.

7. Screw your child restraint at the bottom of the chain.

8. When the shutter is lowered to the correct position, please add the chain stop where the chain enters the drive chain. This will prevent the blind from rolling too far and damaging the flap.

9. Finally, hold the child's safety device to ensure that the cables are out of the reach of children.

More information about for blinds details visit here.